Programming Analog Music On Hold

Programming

To program Music on Hold:

1. System Options form

• Set the Music On Hold option to "Yes".

2. (Optional) Class of Service Options form

• Set Music on Hold on Transfer to "Yes"as desired for each Class of Service.

3. Trunk Circuit Descriptor - E and M form

4. Set the Outgoing Start Type parameter to "Immediate"

5. Set the Transmission Facility parameter to "2 wire"

6. Set the 2 Wire Balanced Network Setting parameter to "600"

7. Set the Perform Seize Test on Out-of-Service Trunks parameter to "No"

8. All other parameters may be any value.

4. E and M Trunks form

• Ensure that the trunk number is unique. The service number, E&M trunk circuit descriptor number, and the interconnect number may be the same as other E&M trunks.

5. System Access Points form

• Set "Music Source" to "External".

• In the "Music Source Port - Location ID" field, enter the PLID of the E&M trunk circuit

  NOTE: Music on Hold can be assigned to either of the first two ports on a Universal ASU E&M card or to the E&M port on the Analog Main Board (AMB) (on a controller with embedded analog). Only one Music on Hold source is permitted per system.

6. If you assigned Music on Hold to an E&M port on the AMB (on a controller with embedded analog) reboot the controller to start Music on Hold operation. Or, if you assigned Music on Hold to a port on a Universal ASU E&M card, reload the Analog Services Unit to start Music on Hold operation.

NOTE: Any omission of programming PLID assignment and or CIM to configured ASU will not permit Music on Hold.

 

• Music on Hold

• Music on Hold On Transfer